E-TECH Bumper corner Protectors
Price:
Availability:
E-TECH Bumper Corner Protectors have been developed to help protect vulnerable protruding painted bumper corners that are easy to knock and scuff and are expensive to repair and respray.
E-TECH Bumper corner protectors are manufactured from a tough impact absorbing flexible PVC material and have an ultra strong self-adhesive backing to keep them secure once fitted.
Available in either black or chrome
Features:
- Will conform to most bumper shapes and contours.
- Manufactured from tough impact absorbing flexible PVC
- Easy to fit, self-adhesive with strong adhesion
- Size: 445mm long x 40mm wide
Contents: 2 x Bumper Protectors 2 x E-TECH Surface Cleaner Sachets 1 x Detailed fitting instructions
Size: 445mm Long x 40mm Wide
Colours available: Black or Chrome
Manufactured from a tough impact absorbing flexible PVC
IMPORTRANT - Read the instructions below before fitting the Bumper Protectors
Thoroughly clean the area where the Bumper Protectors are going to be fitted.
This area must be completely free of all traces of oil, grease, wax, polish, dirt, dust and moisture.
Thoroughly dry the area
FITTING INSTRUCTIONS
Do not fit in temperatures below 13ºC (55ºF) as this effects the adhesion of the product. If the temperature is below 13ºC (55ºF) you can warm the E-TECH Bumper Protector up and the area where it is going to be stuck using a hair dryer or by fitting it in a warm garage.
After you have cleaned the area where the Bumper Protector is going to be fitted use the E-TECH 'Surface Cleaner' sachet provided, wipe around the area where the Bumper Protector is going to be applied. The surface cleaner will prepare the boding area for the Bumper Protector so a strong adhesion is achieved.
When you have decided where you want to fit the Bumper Protector offer it up to the fiting area - make sure you have it in the correct position, peel back only 5 or 6 cms of the backing paper and fold this down to leave a flap. Do not touch the adhesive tape or the bonding srea with your fingers.
Stick the exposed end of the Bumper Protector in position and rub down gently. Pull the flap of the backing paper away from the Bumper Protector a few inches at a time and slowly stick the rest of it in position, rubbing down gently as you go. Once the bumper Protector is in place you cannot re-position it. Repeat the same process fro the other protectors.
The adhesive tape takes time to cure so do not wash car by hand within 3 days of installation and do not put your vehicle through a car wash for 7 days.
We recommend that if you want to fit the product around a tight bend up to a maximum of a 90º angl, you must use some masking tape and stick it over the ends of the Bumper Protector and leave for 24 hours to help the Bumper Protector conform and adhere to the shape to ensure a secure adhesion.