E-TECH C2 Refined Polishing Compound - 500ml
The E-TECH C2 Refined Polishing Compound is the perfect surface defect remover for polishing and reviving painted surfaces that have suffered from neglect and minor damage. Removes swirl marks, light scuffs and fine scratches and minor surface imperfections for a gloss finish.
For use on all types of paint - water or solvent based, clear coat lacquers & varnishes.
Optimum viscosity to retain its moisture and not dry out to fast. Leaves a gloss finish and can be used in conjunction with the E-TECH C3 Ultra Fine Polishing Compound for an ultra-high gloss finish.
Used by paint and body shops, professional polishers, valeters, detailing companies, dedicated enthusiasts in automotive, marine and motorbike applications.
A light polishing compound equivalent to 2000 grit abrasive paper.
Developed for use by hand or mechanical polishers on all types of paint - water or solvent based, clear coat lacquers and varnishes.
Can also be used on glass fibre (polyester) gel coats and coated composites.
ldeal for reviving old, dull, faded and UV damaged paintwork to make it look like new again.
A water based compound consisting of course premium grade abrasives suspended in a thickened emulsion of natural lipids and hydrocarbon waxes in water.
Product is free of ammonia and harmful solvents. Does not contain silicones.
A Low dust formula Polishing compound which for reference is approximately equivalent to 2000 abrasive paper.
Leaves a gloss surface finish.
This product is non-flammable, non-toxic and is classified as non-hazardous to human health and the environment.
Manufactured in the UK to ISO9001:2008 quality standards to ensure optimum performance and consistency.
Shake well before use
Apply a small amount of compound onto a clean micro fibre cloth and rub the area to be polished in small circular motions. Then with a clean part of the cloth buff off to reveal a gloss finish. If you cannot achieve the desired finish using this method we recommend that you then use the mechanical method below.
By Mechanical Method
Set the drill speed between approx 1500-2000 rpm. Apply a small amount of the compound to the centre of a medium firm foam polishing pad; smear the compound around the area to be polished (apply more as required). Then using light to medium pressure move the drill back and forth over the affected area until the desired finish is achieved. Periodically check your polishing progress to ensure you are achieving the desired result.
Be careful not to use excessive hand pressure or hold the drill in one place as this can cause damage to the surface.
We recommend you perform a compatibility test on a small inconspicuous area before using this product and wear protective eyewear.
Do not cross contaminate any polishing cloths or pads with different compounds. After final polishing apply a suitable wax sealer to the surface if required.