E-TECH Chrome Styling Trim
E-TECH Chrome Styling Trim is a self-adhesive 5 metre long roll of automotive trim that can be used to accentuate body lines in bumpers and body panels or anywhere you want to add some subtle exclusive chrome styling. Can be fitted all around your vehicle internally or externally on things like around lights, nyumber plates, bumpers, door panels, door sills etc.
- Designed to highlight vehicle body lines
- Ideal for use on any body panel, bumpers, around lights, number plates etc...
- For internal or external use
- Universal fitting - Simple to fit
- High quality ultra strong adhesive
- 2 x E-TECH Cleaning Sachets provided for a secure fit
- Roll size 5 Metres long and 8mm wide
E-TECH Chrome Styling Trim Roll Size: 5 metres long x 8mm wide x 3mm high
Self adhesive backed Chrome trim
Supplied with 2 x E-TECH Cleaning Sachets
Thoroughly clean the area where the Chrome Styling Trim is going to be fitted.
IMPORTANT - This area must be completely free of all traces of oil, grease, wax, polish, dirt, dust and moisture. Thoroughly dry the area.
Do not fit in temperatures below 55°F (13°C) as this effects the adhesion of the product. If the temperature is below 55°F (13°C) you can warm the Chrome Trim up and the area where it is going to be stuck using a hair dryer or by fitting it in a warm garage.
Using the E-TECH Surface Cleaner Sachet provided, wipe around the area where the Chrome Trim is going to be fitted. The Surface Cleaner will prepare the bonding area for the Chrome Trim so strong adhesion is achieved.
Measure the area where the Chrome Trim is going to be fitted and cut it to the required length - use a sharp knife or pruning shears.
DO NOT STRETCH THE CHROME TRIM WHILE INSTALLING
Peel back only 1 or 2 inches of the backing tape and fold this down to leave a flap.
Stick the exposed end of the Chrome Trim in position and rub down gently. Then pull the flap of the backing paper away from the Chrome Trim a few inches at a time and slowly stick the rest of it in position, rubbing down gently as you go. Once the Chrome Trim is in place it should not be removed.
Rub the Chrome Trim hard 3 or 4 times to ensure that a maximum bond is made. Repeat abovge process after 6 and 24 hours.
This adhesive takes time to cure so please do not wash car within 3 days of installation.