E-TECH Number Plate Security Scew Kit
Price:
Availability:
With vehicle identity theft on the increase these ultra high security fixings help prevent the theft of your front and rear number plate.
If your number plate is stolen, not only do you have the cost of replacing it you also have the inconvienience of possibly being accused of speeding, illegal parking and dodging congestion charges etc. To prove your innocence will be costly and time consuming.
Features:
- Can be used on any number plate on any vehicle
- Enough for both front and rear plates
- No special tools required for fitting
- Very difficult and time consuming to remove
Kit Contents:
4 x Self tapping security screws
4 x Cap washers
4 x Black caps
2 x Blue caps
2 x Yellow caps
2 x White Caps to match every number plate colour
- Decide on the number plate mounting position (you may be able to use the existing holes in the number plate/vehicle)
- If there are no pre-drilled holes in the number plate, you will need to drill 5mm Ø diameter holes in the correct position.Handy Tip: Use masking tape placed over where the hole is going to be drilled, to stop the drill slipping and to reduce the chance of the number plate splitting or cracking
- Offer up the number plate to the mounting position and mark through the holes in the plate on the vehicle. This will act as as a guide when you need to drill the fixings hgoles in your vehicle.
- Drill a small pilot no larger than 3mm Ø in diameter in your vehicle (the holes should be slightly smaller in diameter than the security screws).
- Insert the security screws through plastic washers before screwing the number plate to the vehicle using a standard flat headed screwdriver. Once secured push fit the coloured screw head caps over the washer to hide the security screw.
- Periodically check the tightness of all screws
Tools Required:
Cord/Cordless drill
3mm Ø & 5mm Ø Drill Bits
Flat headed screwdriver
MAkrer Pen/Pensil
Masking Tape