Engine Enamel - Spray Coating - 400ml
Price:
Availability:
E-TECH Engine enamel is a high quality, long lasting, enamel coating specially formulated with a ceramic resin to cope with temperatures of up to 250°C, and is suitable for use on most engine parts and components.
Ideal for engine blocks, valve/rocker covers and gearbox/differential casings, plus other engine bay components.
The spray-on application is simple to apply, quick drying and provides a hard, chip resistant, long lasting finish which will retain its colour due to the high pigment content.
Available in 6 colours: Black, Blue, British Racing Green, Orange, Red and Silver
Features
- Long lasting high quality finish
- Tough chip and crack resistant formula
- Resists oil, engine additives, chemicals, road salt & weathering
- Excellent durability
- No primer needed - strong adhesion to bare steel and metal*
Can Size 400ml
It is a spray on application so quick drying and provides a hard, chip resistant, long lasting finish which retains its colour due to the high pigment content.
* Long term performance of this paint on aluminium and stainless steel surfaces cannot be guaranteed.
Not suitable for brass and other non-ferrous metals
Available in 6 colours: Black, Blue, British Racing Green, Orange, Red and Silver
PREPERATION - IMPORTANT: READ THIS
- For best results ensure the engine or part you are painting, and the paint are at room temperature before use (approx 17°C to 21°C)
- For best results apply in a warm, dry and dust free srea
- Use a steel brush to remove loose dirt and rust deposits from surface to be painted
- Then clean the area to be painted thoroughly with a degreaser or steam cleaner, removing all traces of silicone, oil, dirt, grease etc.
- Mask off any area that you do not want to be painted
- The area to be painted mst be completely dry and thoroughly clean before you start.
APPLICATION
- Shake can vigorously for a minimum of 2 minutes before use.
- Hold can 20-30cm (8-12") from surface and spray using a smooth side to side motion.
- Build up layers with several thin coats allowing approximately 15-20 minutes between coats for the surface to dry to a tacky film (do not apply heavy coats).
- Shake can between coats
- After applying the final coat allow 4 hours for the enamel to dry properly.